No Detail Found!

Experimental investigation on compaction properties of sandy soils.

Author(s)
Hassan Mujtaba Department of Civil Engineering, University of Engineering & Technology, Lahore, Pakistan
Khalid Farooq Department of Civil Engineering, University of Engineering & Technology, Lahore, Pakistan
Imtiaz Rashid Department of Civil Engineering, University of Engineering & Technology, Lahore, Pakistan
Abstract
In this research, an effort has been made to develop a correlation between standard and modified proctor compaction test parameters, i.e., maximum dry unit weight (gdmax) and optimum moisture content (OMC) of sandy soils. Standard and modified proctor along with classification tests were carried out on hundred and twenty sandy soil samples with different grain size distributions. Based on the test results, the soil samples were classified into various groups of medium to fine sand with non-plastic fines up to 45%. Regression analyses were performed on the experimental data and correlations were proposed to express modified Proctor parameters (gdmod and OMCmod) in term of standard Proctor test parameters (gdstd and OMCstd). The validation of the proposed predictive correlations was done by using test results of another set of sandy soil samples not used in the development of the correlations. The results of the analyses showed that variation between experimental and predicted values of gdmod is within ± 4 % confidence interval and that of OMCmod is within ± 2.0 %. Further, based on the test results, an effort has been made to investigate the effect of fines (finer than 75mm) on compaction characteristics. It was observed that gdmax both in case of standard and modified proctor increases with increase in fines content up to 35% and beyond that it decreases. However, the value of OMC in both the cases decreases with increase in fine content. The correlations proposed in this paper may be very useful during the project preliminary/ pre-feasibility stages in the field of Geotechnical Engineering.
Publication Details
Page(s) 115-125
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 14, Issue: 1, Year: 2014

Request the full text from PASTIC

0

Citations

1

Downloads

115

Views