In a study conducted at National Institute of Food Science and Technology, University of Agriculture, Faisalabad, Pakistan during 2012, linseed oil was used to replace shortening in standard cookie formula to check its stability and suitability in baked products. Cookies were prepared with five levels of linseed oil (0, 25, 50, 75 and 100%). Treatments effects were significant while storage effects were found non significant on physical characteristics i.e. width, diameter and spread ratio of cookies. The biscuits prepared from 100 percent linseed oil showed the highest width (279mm) and spread ratio (46.39), while maximum thickness (62.16mm) was noted in standard shortening. The increasing levels of substitution of linseed oil increased proportionately cookie width (275.00 mm in control to 279mm in 100% linseed oil) and spread factor (44.24 in control to 46.39 in 100% linseed oil). There was a linear decrease in cookies thickness from 62.16mm (control) to 60.14mm (100% linseed oil) with increasing levels of substitution. Different levels of linseed oil substitution for cookies preparation and their storage depicted significant differences for moisture, fat and nitrogen free extract (NFE) contents while non significant differences were recorded for protein, fiber and ash contents. Maximum mean values for protein (7.81%), ash (0.63%) and fibre (0.22%) were recorded in cookies prepared from 50 percent substitution of linseed oil. The cookies prepared with standard shortening depicted maximum moisture (3.06%) whereas, maximum fat contents (25.18%) were recorded for cookies prepared from 25 percent replacement of shortening with linseed oil. However, the highest NFE values (65.57%) were recorded for cookies made from 75 percent substitution of shortening with linseed oil. The data further showed that moisture content increased while protein, ash, fat, fibre and NFE contents decreased with increased storage duration.