No Detail Found!

Design of X and R control charts for armature resistance process towards achievements of six-sigma process improvements.

Author(s)
Abdul Sattar Jamali Department of Mechanical Engineering, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
Abdul Latif Manganhar Department of Mechanical Engineering, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
Muhammad Sharif Jamali Department of Mechanical Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
Control charts are one of the most appropriate and effective tools for process control in order to achieve Six-Sigma quality. Fundamental approach was applied to design the X and R-control charts for Armature Resistance process. Both charts were plotted through Minitab Quality Software and exhibited control, but only one sample range observed 0.19 ohms at point 25 at the end of UCL (Upper Control Limit) which, is suggested to be given more attention in order to save the process out-of control. Incase design control charts seems to be not under control as per customer requirement, and then it is suggested to calculate the process capability for the said purpose.
Publication Details
Page(s) 17-22
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 24, Issue: 1, Year: 2005

Request the full text from PASTIC

0

Citations

0

Downloads

50

Views