No Detail Found!

CFD flow modeling of riser exit geometries of a circulating fluidized bed.

Author(s)
Ahmed Hussain Faculty of Mechanical Engineering, Universti Teknology Malaysia. 81310 UTM Skudai, Johor, Malaysia
Farid Nasirani Faculty of Mechanical Engineering, Universti Teknology Malaysia. 81310 UTM Skudai, Johor, Malaysia
Abstract
The type and configuration of the exit used at the top of a CFB can have a significant impact upon the suspension dynamics of CFBs (Circulating Fluidized Beds). This paper is meant to quantify these effects. The riser exits namely; right angle, blind T and right angle with internal baffles are commonly used in industrial CFB. The effects of these riser exits on CFB hydrodynamics was investigated using CFD (Computational Fluid Dynamics) software. Simulation was done using FLUENT, a CFD package by Fluent Inc. Sand particles and air were used as the solid and gas phases, respectively. The simulations were done using the geometrical configuration of a CFB test rig at the UTM (Universiti Teknologi Malaysia). The results discuss the variation of velocity contours, along the riser column, due to change in riser exit geometry. The effect is significant in the upper region of the riser column and the velocity contours are also influenced by the exit geometry. Simulations discusses the solid volume fraction distribution in the upstream region of riser exit.
Publication Details
Page(s) 181-190
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 24, Issue: 3, Year: 2005

Request the full text from PASTIC

0

Citations

0

Downloads

28

Views