No Detail Found!

Description and analysis of a new air pump for agricultural irrigation.

Author(s)
Seyed Saeid Mohtasebi Department of BIO-System Engineering, Tehran University, Iran
Mansoor Behroozi-Lar Department of BIO-System Engineering, Tehran University, Iran
Amir Nafari-Ghaleh Department of BIO-System Engineering, Tehran University, Iran
Abstract
Different principles have been used to water pumping by compressed air. The one implemented here uses the principles of a simple piston pump except that compressed air is used instead of the mechanical piston. A compressor installed on the ground, sends air flow to a double wall chamber inside the well through a single hose line. Air flow is cut on and off by hydraulic valves which also located on the ground surface. Two necessary check valves for the piston pump to operate, however, are installed in the double wall chamber in the well. Instead of the old metal shaft and tube, a high pressure plastic tube is implemented to carry the water up on to the ground surface from the well. To start modeling, first, the mathematical equations of various sections of the system are presented and then based on those equations, the mathematical model of whole system is derived. To evaluate the model, the results obtained from simulation are compared with experimental results.
Publication Details
Page(s) 601-603
DOI DOI not available
Published Journal: International Journal of Agriculture and Biology, Volume: 7, Issue: 4, Year: 2005

Request the full text from PASTIC

0

Citations

0

Downloads

90

Views