This research investigates AC induction motor shaft voltage current flow through motor bearings and eclectic discharge current problems within bearings when operated under both pure sine wave and Pulse Width Modulated (PWM) inverter sources. Recent experience suggests that PWM voltage sources with steep Wave fronts especially increase the magnitude of the above electrical problems, leading to motor bearing material erosion and early mechanical failure. It has been proved that it is not pure electromagnetic phenomenon but under PWM operation these same problems are predominantly an electrostatic phenomenon. The model has been prepared and capacitance (stator to frame, stator rotor, rotor to frame), common mode voltage and common mode current have been identified which cause shaft voltage and bearing current. Some possible solution has been presented to reduce bearing current and shaft voltage.