No Detail Found!

Study of analytical creep theory by using two dimensional finite difference computer model.

Author(s)
H. F. Gabriel National Institute of Transportation (NIT), National University of Science & Technology, Risalpur Campus, NWFP, Pakistan
G. D. Khan Department of Water Management, NWFP Agricultural University, Peshawar, Pakistan
I. A. Umar Centre of Excellence in Water Resources Engineering, University of Engineering. & Technology, Lahore, Pakistan
Abstract
A number of structures were built on the basis Bligh’s creep theory. Some of them were successful while others failed. Therefore further investigations were required to find out sound and scientific techniques for the design of low head structures. The present work is carried out for the verification of analytical creep theory, which is over due, for the future designing of hydraulic structures. The main objective is to study seepage under hydraulic structures the using the numerical models. The results obtained by two-dimensional finite difference computer model are compared with the results of analytical theory. To initiate and to understand the methodology of a numerical model technique, a sample seepage problem was studied. This experience was used to modify Rush-ton (1979) model to solve seepage problems. Analysis of numerical model results shows that seepage under hydraulic structure is a complex problem, which can be properly solved using a numerical model. Comparison of numerical model results with Bligh’s Creep theory show that Bligh’s theory considers linear distribution of potential along the creep length whereas actual distribution is non-linear. Bligh’s theory is a conservative yet simple approach but it is not applicable to complex field situations where the soil properties vary widely below hydraulic structures. The effect of sheet pile positions also cannot be properly considered in Bligh’s theory.
Publication Details
Page(s) 21-26
DOI DOI not available
Published Journal: Quaid-e-Awam University Research Journal of Engineering, Science and Technology, Volume: 5, Issue: 1, Year: 2004

Request the full text from PASTIC

0

Citations

0

Downloads

20

Views