No Detail Found!

Effect of various tillage practices on selected physical properties in clay loam soil under wheat – maize rotation.

Author(s)
Mansoor Khan Khattak Department of Agricultural Mechanization, NWFP Agricultural University, Peshawar, Pakistan
Abdul Qadir Mughal Higher Education Commission (HEC), Islamabad, Pakistan
Mohammad Jamal Khan Department of Soil & Environmental Sciences, NWFP Agricultural University, Peshawar, Pakistan
Sheruddin B. Bukhari Department of Farm Power & Machinery Sindh Agricultural University, Tandojam, Pakistan
Gul Daraz Khan Department of Water Management, NWFP Agricultural University, Peshawar, Pakistan
Abstract
The research study was conducted with the objectives to evaluate the effect of various tillage practices on selected soil parameters including bulk density and soil strength under wheat – maize rotation at NWFP Agricultural University Research Farm, Peshawar during 1996-99. Five implements viz; moldboard plow, disk plow, cultivator, disk harrow and rotavator were used alone and in various combinations. The experiment was laid out in randomized complete block design (RCBD) with replication. The results showed that tillage treatments had significant effects on soil bulk density at various depths. On an average field prepared by moldboard plow + rotavator (MIRI) and disk plow + cultivator two times (DIC2) gave lower bulk density as compared to other tillage treatments. By comparing bulk density of two depths during three consecutive years (1996-99) of wheat – maize rotations, it was noted that at 0-21 cm depth, the minimum bulk density of 1.46 g cm-3 was found in deep tillage plots and the higher bulk density of 1.52 g cm-3 was recorded in cultivator plots. In case of 22-42 cm depth, minimum (1.57 g cm-3) bulk density were found in deep tillage plots and the maximum (1.62 g cm-3) bulk density was noted in shallow tillage plots. These variations were attributed to breaking, inverting and pulverizing of sub-surface by deep tillage treatments as compared to shallow tillage treatments. Various tillage treatments as 0=21 cm depth has significant effect on soil strength. Least soil strength of 63 N cm-2 (17% less) was found in moldboard plow and disk plow plots, while the highest soil strength of 80 N cm-2 was observed in the cultivator plots under wheat – maize rotations during 1996-99. Similarly, deep tillage treatments by moldboard plow or disk plow gave lowest value of 121 N cm-2 (20% less) soil penetration resistance up to their plowing depth and the shallow tillage treatments by cultivator gave highest value of 141 N cm-2 at 22-42 cm depths under wheat-maize rotations during 1996-99.
Publication Details
Page(s) 223-241
DOI DOI not available
Published Journal: Sarhad Journal of Agriculture, Volume: 20, Issue: 2, Year: 2004

Request the full text from PASTIC

0

Citations

0

Downloads

53

Views