No Detail Found!

In-Situ combustion of heavy crude oil in a consolidate porous media using a disc type reactor.

Author(s)
Rafique Akhtar Kazi Institute of Petroleum and Natural Gas Engineering, Mehran University of Engineering and Technology, Jamshoro, Pakistan
Abstract
Thermal recovery is the most mature technology available for (EOR) (Enhanced Oil Recovery).Thermal processes, and are particularly applicable to the recovery of heavy oils and tar sands. In-situ heat generation processes require combination within the reservoir. These processes are categorized as either forward combustion, reverse combustion, or wet combustion. A high pressure disc type reactor has been used to study the effect of the main variables thought to affect the kinetics of heavy oil in a consolidated porous media on combustion. The processes observed were very dependent on the conditions used. The rate of oxygen consumption and carbon burning rate increased when the air flux is increased. This behavior is attributed to the overall increase in the rate of oxidation. When the heating rate was reduced from 50C min-1 to 1.50C min-1 with constant inlet flux, LTO (Low Temperature Oxidation) reactions were found more significant. In addition, the rate of fuel burning reaction HTO (High Temperature Oxidation) decreased with decreased heating rate. The change in the rate of the fuel burning reaction is attributed to the change in the nature of the fuel burnt in consolidated formation.
Publication Details
Page(s) 253-260
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 22, Issue: 4, Year: 2003

Request the full text from PASTIC

0

Citations

0

Downloads

137

Views