No Detail Found!

Development of electrical analogue model for studying seepage flow under hydraulic structures-case study: Sukkur Barrage.

Author(s)
H. F. Gabriel Center of Excellence in Water Resources Engineering, UET, Lahore, Pakistan
Imtiaz Ahmad Umar Center of Excellence in Water Resources Engineering, UET, Lahore, Pakistan
Gul Daraz Khan Department of Water Management, NWFP Agricultural University, Peshawar, Pakistan
Abstract
For the solution of groundwater problem many types of models are used, but electrical analogue model is preferred due to its close response with its prototype hydrological system. This model is easy to construct and is reusable. In the model voltage is correlated to groundwater head, electric current to flow and capacitance to ground-water storage. The analogy of the model is derived based on Kirchhoff’s law and Finite difference form of Lap lace equation. The network is consisting of square and rectangular meshes. Scaling factor for voltage and resistors are selected. All the equipments needed for assembling the model are prepared. Terminal strips and their connectivity are checked. Calculated resistors with accurate values after cutting and molding are inserted in the terminal strips and desired section is completed. A network of resistors in X and Z direction is used to represent the aquifer. Two stabilized power supply are used to provide the electrical potential. The worst condition is maintained by supplying the maximum head at upstream and dry condition at downstream. After the development of the model conclusion derived shows that the model is in a position to express the groundwater potential for seepage distribution under the floor with high degree of accuracy. Moreover there is a very good proportion between sample and the actual prototype in existence. The actual model when tested by model show very clear results for the sheet pile in relation to floor length to control seepage or uplift pressure caused. The existing design of Sukkur barrage and its overestimation and underestimation with reference to their sheet pile have been specifically determined.
Publication Details
Page(s) 26-34
DOI DOI not available
Published Journal: Journal of Engineering and Applied Sciences, Volume: 22, Issue: 1, Year: 2003

Request the full text from PASTIC

0

Citations

0

Downloads

58

Views