Brown algae, Sargassum stolonifolium Phang et Yoshida, was extracted using four different solvent systems -viz; phosphate buffer (pH 7.8), chloroform/methanol/water (C/M/W) (2:2:1:1.8), diethyl ether, and benzene. Efficiency of these solvent systems in extracting any inherently available anti-microbial compounds was investigated by testing the extracts against a wide range of bacteria and fungus. Study revealed that anti-microbial activity of this alga is not uniformly distributed in these extracts. Chloroform/methanol/water extract exhibited potent anti-microbial activity by inhibiting 83% of the, tested bacteria and fungus. Phosphate buffer extract showed moderate anti-microbial activity by inhibiting 50% of the bacteria and 3.3% of the fungus. The other two extracts, diethyl ether and benzene extract inhibited 50% and 66% of the tested bacteria and fungus, respectively. Lowest MIC values were in the range of 10 - 20 μgdisc-1 for C/M/W extract against bacteria and fungus. On the other hand, phosphate buffer extract showed the highest MIC values in the range of 60 - 80 μgdisc-1 and 100 - 140 μgdisc-1 against bacteria and fungus, respectively. Hence, best anti-microbial activity was manifested by C/M/W crude extract. Further analysis of C/M/W extract via "bioassay guided separation methodology" resulted in the isolation of the active anti-microbial constituents. These compounds were identified via Thin Layer Chromatography (TLC) (visualized with specific spray reagents), H-NMR, C-NMR, 2D-NMR and GC techniques. Based on the GC and spectral data, active compounds were identified as free fatty acids and MGDGs (β-galactopyranosyl (1`- 3, 2 - sn - diacyloglycerols. These compounds were present in the highest concentration in C/M/W extract, hence suggesting that the strength of active principles in any given extract depends on the usages of suitable solvent system in the extraction process