No Detail Found!

Investigation of Thermohydraulic Performance of Multiple Tube Pass Heat Exchanger with Baffles

Author(s)
Muhammad Ali Kamran Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Muhammad Alam Zaib Khan Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Zahid Hussain Shah Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Usman Jadoon Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Shayan Javed Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Adil Shareen Department of Mechanical Engineering, University of Engineering and Technology,Peshawar 25120,Pakistan
Abstract
Shell side design and analysis of a small shell and tube heat exchanger with baffles and two tube passes is reported. The effect of different baffle spacing on parameters such as heat transfer, Number of Transfer units (NTU) and pressure drops was studied using numerical and experimental techniques to identify the inter baffle spacing for optimal thermohydraulic performance. Contrary to earlier studies in this area, both the shell and tube fluids along with channels were modeled for multiple tube passes; besides conduction effects along the baffle were also considered. Segmented baffles with a baffle cut of 20% were simulated in ANSYS for multiple inlet temperatures. Turbulence was modeled using the realizable k-e scheme while the Bell-Delaware method was employed for pressure drops. Increase in heat transfer was observed when the number of baffles was increased, but an inter baffle spacing ratio of 0.41 was identified to be the optimal for thermohydraulic performance. Experimental investigation conducted to gauge the reliability of the results displayed a close match showing that the current numerical methodology can be used to design and assess industrial heat exchangers with segmented baffles and multiple tube passes.
Publication Details
Page(s) 10-29
DOI DOI not available
Published Journal: The Sciencetech, Volume: 4, Issue: 2, Year: 2023

Request the full text from PASTIC

Keywords
Segmented baffles, Baffle Spacing, Heat exchangers, Multiple tube passes, Computational
References
Andrews M. J.,Master B. I. .2005 .Three Dimensional Modeling of a Helixchanger Heat Exchanger using CFD. Heat Transfer Engineering, 26(6) : 22-31.
Bell K. J. .1963 .. Final Report of the Cooperative Research Program on Shell and Tube Heat Exchangers, bulletin no. 5, : .
Bergman T. L.,Lavine A. S.,Incropera F. P.,Dewitt D. P. .2011 .Fundamentals of Heat and Mass Transfer. , : .
Biswas G.,Eswaran V. .2002 .Turbulent Flows, Fundamentals, Experiments and Modeling. , : .
Cao E.,McGraw-Hill Education E. .2010 .Heat transfer in process engineering (1st ed. , : .
Cengel Y. A. .2003 .Heat Transfer: A Practical Approach. , : .
Jain A.,Jain K. K.,Patel S. .2015 .Comparative study of different CFD models to evaluate Heat Transfer and Flow parameters in STHE. International Journal of Engineering Sciences and Research Technology, 536 : 547.
Jozaei A. F.,Baheri A.,Hafshejani M. K.,Arad A.,Falavan A. .2012 .Optimization of Baffle Spacing on Heat Transfer, Pressure Drop and Estimated Price in a Shell-and-Tube Heat Exchanger. World applied Sciences Journal, 18(12) : 1727-1736.
Kakac S.,Hongtan L. .2000 .Heat Exchangers: selection, rating and thermal design. , : .
Kern D.,Hill D. .1997 .Process Heat Transfer. , : .
Kottke H. L. .1999 .Analysis of local shellside heat and mass transfer in the shell-and-tube heat exchanger with disc-and-doughnut baffles. International Journal of Heat and Mass Transfer, 42(18) : 3509-3521.
Liu J. Y. .2015 .Numerical investigation on a novel shelland-tube heat exchanger with plate baffles and experimental validation. Energy Conversion and Management, 101 : 689-696.
Master B. I.,Chunangad K. S.,Pushpanathan V. .2003 .Fouling mitigation using helixchanger heat exchangers. Proceedings of the ECI Conference on Heat Exchanger Fouling and Cleaning: Fundamentals and Applications, : 317-322.
Mukherjee R. .1998 .Effectively Design Shell-and-Tube heat exchangers. Chemical Engineering Progress, 94 : 21-37.
Ozden E.,Tari I. .2010 .Shell Side CFD Analysis of a small shelland-tube heat exchanger. Energy Conversion and Management, 51 : 1004-1014.
Pal E.,Kumar I.,Joshi J.,Maheshwari N. .2016 .CFD simulations of shell-side flow in a shell-and-tube type heat exchanger with and without baffles. Chemical Engineering Science, 143 : 314-340.
Prithiviraj M.,Andrews M.,Part A .1998 .Three dimensional numerical simulation of shell-and-tube heat exchangers. Part 1: foundation and fluid mechanics. Numerical Heat Transfer, 33 : 799.
Stehlik P.,Nemcansky J.,Kral D.,Swanson L. W. .1994 .Comparison of Correction Factors for Shell and Tube Heat Exchangers with Segmented or Helical Baffles. Heat Transfer Engineering, 15(1) : 55-65.
Sun Y,W. X. Y .2019 .Numerical Investigation and Optimization on Shell Side Performance of A Shell and Tube Heat Exchanger with Inclined Trefoil-Hole Baffles. , 12(21) : 4138-4160.
Sunden B. .2007 .Computational Fluid Dynamics in Research and Design of Heat Exchangers. Heat Transfer Engineering, 28(11) : 898-910.
Wang J. Q.,Chen Q.,Chen G.,Zing M. .2009 .Numerical Investigation on Combine Multiple Shell-Pass Shell and Tube Heat Exchanger wih Continuous Helical Baffles. Inernational Journal of Heat and Mass Transfer, 52 : 1214-1222.
Wang J. Q.,Chen Q.,Chen G.,Zing M. .2009 .Numerical InvestIgation on Combine Multiple Shell-Pass Shell and Tube Heat Exchanger wih Continuous Helical Baffles. Inernational Journal of Heat and Mass Transfer, 52 : 1214-1222.
Williams P. S.,Knudsen J. G. .1963 .Local rates of heat transfer and pressure losses in the vicinity of annular orifices. The Canadian Journal of Chemical Engineering, 41 : 56-61.
Xianhe D.,Songjiu D. .1998 .Investigation of Heat Transfer Enhancement of Roughened Tube Bundles Supported by Ring or Rod Supports. Heat Transfer Engineering, 19(2) : 21-27.
Yang J.,Liu W. .2015 .Numerical investigation on a novel shell and tube heat exchanger with plate baffles and experimental validation. Energy Conversion and Management, 101 : 689-696.
Yang J.,Ma L.,Bock J.,Jacobi A.,Liu W. .2014 .A Comparison of Four Numerical Modeling Approaches for Enhanced Shell-andTube Heat Exchangers with Experimental Validation. , 65 : 369-383.
Yonghua Y.,Yuqi C.,Mergqian X.,Xiaobing L.,Loan J.,Suyi H. .2015 .Numerical Simulation and Perfomance Improvement for a Small Size Shell and Tube Heat Exchanger with Tre-Foil-Holes Baffles. , 89 : 220-228.
You Y.,Fan A.,Liu W.,Huang S. .2012 .Thermo-hydraulic characteristics of laminar flow in an enhanced tube with conical strip inserts. International Journal of Thermal Sciences, 61 : 28-37.
You Y.,Shufang X.,Pan N.,Deng Z. .2018 .Full Model Simulation of Shellside Thermal Augmentation of Small Heat Exchanger with Two Tube Passes. Heat Transfer Engineering, 39(12) : 1024-1035.
0

Citations

0

Downloads

10

Views