No Detail Found!

Design, Fabrication, and CFD-Based Performance Analysis of a Gravitational Water Vortex Turbine

Author(s)
Nasir Akbar Department of Mechanical Engineering, University of Engineering & Technology Mardan, 23200, Pakistan
Malik Sarmad Zahid Department of Mechanical Engineering, University of Engineering & Technology Mardan, 23200, Pakistan
Arshad Ali Khan Department of Mechanical Engineering, University of Engineering & Technology Peshawar-Jalozai Campus, 24100, Pakistan
Hazrat Ali Department of Mechanical Engineering, University of Engineering & Technology Mardan, 23200, Pakistan
Muhammad Adil Department of Mechanical Engineering, University of Engineering & Technology Mardan, 23200, Pakistan
Abstract
Gravitational Water Vortex Turbines (GWVTs) provide a cost-effective and sustainable solution for rural electrification under low-head conditions. This research presents the fabrication and experimental evaluation of a cylindrical basin prototype (50 cm diameter, 50 cm height) to study the influence of vortex height, blade position, and orifice-to-basin diameter ratios on turbine performance. Orifice sizes of 8, 10, 12, and 14 cm (16-28% ratios) were tested with blade placements at 2 cm, 7 cm, and 10 cm, across vortex heights ranging from 18-48 cm. Results show that vortex height is the primary driver of performance, with Revolutions Per Minute (RPM) and power output increasing up to 40-43 cm before plateauing due to turbulence. The stable performance was leading to 24% orifice-to-basin ratio with the maximum power output of approximately 2.3mW as well as an overall hydraulic to mechanical energy conversion efficiency of approximately 8.8% at a vortex height of 35 cm, whereas the speed of the turbine was approximately 115 RPM at 40 cm. The blades' position of 22 cm maximized torque capture, whereas deeper blades generated higher speeds (125-155RPM) but minimized electrical power. Smaller orifice ratios (16-20%) concentrated flow and performed better at higher vortex heights, while the 28% ratio showed efficiency losses from turbulence. Overall, the findings confirm that a 24% orifice-to-basin ratio with mid-range vortex heights (30-40 cm) and blade depths of 10-22 cm provides the most effective balance of RPM, power, and efficiency, making GWVTs a practical low-head micro-hydro technology for decentralized rural energy generation.
Publication Details
Page(s) 143-165
DOI DOI not available
Published Journal: The Sciencetech, Volume: 6, Issue: 4, Year: 2025

Request the full text from PASTIC

Keywords
Gravitational Water Vortex Turbine, Micro-hydro Power, Rotational speed, power output, Blade Height, Turbine Efficiency, Vortex Height, Orifice-to-basin Diameter Ratio
References
Guzmán Alzamora,Glasscock V. J.,J. A. V. J. .2021 .Analytical solution for a strong free-surface water vortex describing flow in a fullscale gravitational vortex hydropower system. Water Science and Engineering, 14(1) : 72-79.
Zamora-Juárez Ángel,Hugo M.,Leonardo V.,FerriñoFierro V.,Luis A.,J. A.,Miguel C.,Miguel B.,B. B. .2024 .Assessment of a prototype of gravitational water vortex turbine: experimental validation of efficiency. , 26 : 691-711.
Camillus J.,Tokit E. M.,Rosli M. A. M.,Sa M. A. M.,Herawan F. A. Z. M.,Syahputra S. G.,S. I. A. S. G. .2051 .Conceptual design of gravitational water vortex turbine for green energy generation. Journal of Physics: Conference Series, 1 : .
Kueh T. C.,Beh S. L.,Ooi Y. S.,Rilling D. G. .2017 .Experimental study to the influences of rotational speed and blade shape on water vortex turbine performance. Journal of Physics: Conference Series, 822(1) : 012066.
Maika N.,Lin W.,Khatamifar M. .2023 .A Review of Gravitational Water Vortex Hydro Turbine Systems for Hydropower Generation. Energies, 16(14) : 5394.
Nikam S.,Pawaskar S.,Thakur M.,Pawar S. .2020 .Performance Analysis of Gravitational Vortex Hydro-Turbine.. , : .
Nishi Y.,Suzuo R.,Sukemori D.,Inagaki T. .2020 .Loss analysis of gravitation vortex type water turbine and influence of flow rate on the turbine's performance. Renewable Energy, 155 : 1103-1117.
Obozov A.,Akparaliev R.,Mederov T.,Ashimbekova B.,Tolomushev A.,Orazbaev K. .2023 .Research and development of a gravitational water vortex micro-HPP in the conditions of Kyrgyzstan. Energy Reports, 10 : 544-557.
Rahman M. M.,Tan J. H.,Fadzlita M. T.,Wan Khairul Muzammil A. R. .2017 .A Review on the Development of Gravitational Water Vortex Power Plant as Alternative Renewable Energy Resources. IOP Conference Series: Materials Science and Engineering, 217(1) : 012007.
Rehman W.,Ijaz M.,Munir A. .2017 .Power Division (Publication) POWER, 2. , : .
Timilsina A. B.,Mulligan S.,Bajracharya T. R. .2018 .Water vortex hydropower technology: a state-of-the-art review of developmental trends. Clean Technologies and Environmental Policy, 20(8) : 1737-1760.
Vinayakumar B.,Antony R.,Binson V. A.,Youhan S. .2024 .Experimental and numerical study on gravitational water vortex power plant for small water bodies. , 7 : 100460.
Vinayakumar B. .2022 ."Gravitational water vortex: Finite element analysis based design and implementation. " Chemical and Process Engineering: New Frontiers 43.3, : 357-368.
Yaakob O. B.,Ahmed Y. M.,Elbatran A. H.,Shabara H. M. .2014 .A review on micro hydro gravitational vortex power and turbine systems. Jurnal Teknologi (Sciences and Engineering), 69(7) : 1-7.
Zamora-Juárez M. A.,Guerra-Cobián V. H.,Ortiz Fonseca,C. R. Fonseca,B. M. Fonseca,Fierro Ferriño,Bruster Flores A. L.,J. L. A. L. .2022 .Performance of modified gravitational water vortex turbine through CFD for hydro power generation on micro-scale. Journal of the Brazilian Society of Mechanical Sciences and Engineering, 44(11) : 1-19.
Zainal ,Hussein M.,Omer K.,Ahmed K. .2025 ."Operational, design, and economic factors impacting gravitational water vortex hydropower systems. " Journal of Thermal Engineering, 11 : .
0

Citations

0

Downloads

8

Views