No Detail Found!

Surface modification of al-alloy by using glow discharge plasma.

Author(s)
M. Shoaib Shah Department of Physics, G. C. University, Lahore, Pakistan
Murtaza Saleem Department of Physics, G. C. University, Lahore, Pakistan
M. Kashif Department of Physics, G. C. University, Lahore, Pakistan
A. Qayyum Department of Physics, G. C. University, Lahore, Pakistan
R. Ahmad Department of Physics, G. C. University, Lahore, Pakistan
Abstract
Surface modification of aluminum alloy (AlFe1.8 Zn0.8) samples is executed by exposing them in nitrogen-argon mixture (1:1) plasma for different filling pressures (1-3 mbar) by keeping the input power level at 100 watts and substrate temperature at 250°C. Langmuir probe I-V characteristic curve recorded at different filling pressures is used for the measurements of plasma parameters (electron temperature and density). It is found that electron temperature decreases whereas electron density increases with increase in filling gas pressure. Aluminum alloy samples treated for different time durations (3, 6, 9 and 12 hours) are characterized by using X-ray diffractometer (XRD) and micro hardness tester. The XRD results reveal the formation of cubic aluminum nitride (AIN) thin film. The grain size of the samples is measured by using Scherrer`s formula and significant decrease in crystalline size is observed owing to the nitrogen infusion interstitially causing deformation in the material. Considerable increase in the surface hardness is observed when the samples are treated for 12 hours at 1mbar filling pressure.
Publication Details
Page(s) 31-41
DOI DOI not available
Published Journal: Journal of Natural Sciences and mathematics, Volume: 45, Issue: 1--2, Year: 2005

Request the full text from PASTIC

0

Citations

0

Downloads

61

Views