The Southern Kirthar Fold Belt (SKFB) represents the southernmost continuation of the regional Himalayan-Suleiman- Kirthar orogenic system. This orogenic belt formed as a result of the oblique continent to continent impact amid the Eurasian and Indian Plates. The SKFB lies head-to-head to the Indian Plate’s western transpressional edge, which is delineated by the Ornach Nal Chaman Fault System. To the east, the SKFB is bounded by the Sindh monocline. To the north, it transitions into the Kirthar Foredeep plus the Central Fold Belt of Kirthar. In the south, the western part of the SKFB passes into the Offshore SW-NE trending Murray Ridge, while its eastern segment is bounded by the Sindh monocline along the Karachi Keenjhar right lateral Boundary Fault (KKBF). The present transpressional regime was preceded by multiple rifting events during the Jurassic and Cretaceous periods. The SKFB has traditionally been interpreted as a thin-skinned imbricate fan system, developed above a detachment located within the shales of the Early Cretaceous Sembar and Goru Formations at depths of 3-4 Km below sea-level. However, the influence of Mesozoic extensional structures on the development of later contractional folds has received little attention. This study aims to reinterpret the frontal folds of the SKFB using a thick-skinned deformation template, which involves the inversion of preexisting Jurassic extensional faults.Surface geological data and subsurface well data from different folds across the SKFB were utilized to construct balanced cross-sections. Initial attempts to balance the cross-section using a thinskinned framework, placing the detachment within the Early Cretaceous Sembar and Goru shales, proved unsuccessful. Instead, a sub-vertical fault geometry beneath the folds was required to achieve balance, rather than a shallow subhorizontal detachment with an emergent thrust. The sub-vertical fault geometry indicates the role of inverted extensional fault in fold development. These extensional faults interpreted to have formed within the Jurassic Chiltan Formation, which was deposited during early to middle Jurassic rifting of the Indian Plate from the Western Gondwanaland. The thick-skinned interpretation is further supported by analysis of shortening magnitude. Thin-skinned fold-thrust systems usually accommodate considerable horizontal shortening, whereas thick-skinned inversion structures accommodate significantly less. The folds analyzed in this study accommodated only 200 to 500 m of shortening, representing less than 10 % of the total tectonic shortening. Therefore, present study here supports a thick-skinned deformation model for the SKFB, driven by the inversion of extensional faults (Jurassic) during the collision of the Indian Plate (Cenozoic) with the Eurasia.