After monsoon season (July-Sept), the winter season (Jan-March) is the second highest with respect to the occurrence of rainfall in Pakistan. Rainfall in this season is important for Rabi crops (especially wheat) of the country. In this study, Regional Climate Model of the third generation (RegCM3) has been experimentally used in seasonal simulation of Rainfall in Pakistan using ERA-40 reanalysis of European Centre for Medium-Range Weather Forecasts (ECMWF) as initial and lateral boundary conditions for driving the RegCM3. The performance of RegCM3 (Feb-2005 version) is examined through experiments to simulate the amount of winter-2000 precipitation in Pakistan with model resolution of 60km. Winter-2000 is the part of history`s worst drought conditions that occurred during 1998-2001 over Pakistan and the country received 47.5% below normal rainfall during the season. Simulations are performed using two different model domains. The purpose is to see up to what extent the model is capable of capturing the drought conditions over Pakistan during the season and also to ascertain the suitable model domain for the winter season. The model outputs are compared with the observational grid data of Climatic Research Unit (CRU) and real time data of Pakistan Meteorological Department (PMD). It is found that the simulation of winter rainfall over Pakistan is reasonably well captured by the model and the simulation of seasonal precipitation is affected by the domain size. The amount of simulated winter rainfall with Smaller Domain (SD) is found to be comparatively higher than that with Larger Domain (LD) over Pakistan. As compared to the amount of simulated rainfall with LD, the rainfall with SD is also found to be in close approximation with Climatic Research Unit (CRU) data and the real time data of PMD. However, the area weighted rainfall as simulated with SD is just 0.2% above to what calculated from Climatic Research Unit (CRU) data and almost 12% less than the real time data of PMD.