No Detail Found!

The influence of CSM reinforcement on adhesive wear and friction characteristics of plain polyester resin using bor technique.

Author(s)
B. F. Yousif Faculty of Engineering and Technology, Multimedia University Jalan Ayer Keroh lama, Melaka, Malaysia
N. S. M. Ei-Tayeb Faculty of Engineering and Technology, Multimedia University Jalan Ayer Keroh lama, Melaka, Malaysia
Abstract
In this paper, a summary of previous studies on tribo-engineering materials is introduced. In addition, tribilogical investigations on chopped strand mat glass fibers (CSM) reinforced polyester (CGRP) and neat polyester (NP) are evaluated under dry contact condition using Block-on-Ring (BOR) technique. The effects of parallel and anti-parallel orientations of (CSM), load (30-100N), sliding velocity (2.8 and 3.9ms), and sliding distance (1.2-7 km) were studied. Weight loss friction coefficient and interface temperature of both materials were measured and presented as a function of applied load. Scanning electron microscopy (SEM) was conducted to better understand the damage features of the worn surfaces. Results revealed that substantial improvement in the wear and friction characteristics of neat polyester was achieved by reinforcement with CSM. Wear and friction behavior of both CGRP composite and neat polyester are strongly dependant on test parameters. Furthermore lower weight loss friction coefficient and interface temperature was evident when CGRP composite was tested in parallel orientation. SEM showed different damage features in CGRP composite and NP such debonding of fibers, matrix deformation, crack and break of fibers.
Publication Details
Page(s) 11-18
DOI DOI not available
Published Journal: Science International, Volume: 19, Issue: 1, Year: 2007

Request the full text from PASTIC

0

Citations

0

Downloads

133

Views