No Detail Found!

Effect of coolant-to-freestream velocity ratios on film cooling adiabatic effectiveness for a simple planar blade test section using fluent.

Author(s)
M. J. Hyder Department of Mechanical Engineering, PIEAS, Islamabad, Pakistan
F. H. Asghar Department of Nuclear Engineering, PIEAS, Islamabad, Pakistan
Abstract
The effect of coolant-to-freestream velocity ratios on film cooling adiabatic effectiveness has been presented. These measurements were taken under high free-stream turbulence intensity (12%) conditions, representative of operating gas turbine engines. Coolant is supplied to the film cooling hole by means of circular pipe with length to diameter ratio of 7.0. The geometry has a single film cooling hole with 35°-inclined streamwise injection. The film cooling flow is supplied at the temperature of 500 k and free stream flow is supplied at 1175 k. GAMBIT is used for geometry drawing and mesh generation, while FLUENT 6.2 is used for solving flow problem. Ten coolant-to­-freestream velocity ratios ranging from 0.1 to 1.0 with an increment of 0.1 have been investigated. The results document the effect of velocity ratios on film cooling adiabatic effectiveness.
Publication Details
Page(s) 174-185
DOI DOI not available
Published Journal: Proceedings 5th International Bhurban Conference on Applied Sciences and Technology , Volume: 0, Issue: 0, Year: 2007

Request the full text from PASTIC

0

Citations

0

Downloads

161

Views