No Detail Found!

Influenced of various tillage practices on selected physical properties of sandy loam soil under rainfed area.

Author(s)
M. Jamal Khan Department of Water Management, NWFP Agricultural University, Peshawar, Pakistan
Mansoor Khan Khattak Department of Agricultural Mechanization, NWFP Agricultural University, Peshawar, Pakistan
Said Wahab Department of Food Science and Technology, NWFP Agricultural University, Peshawar, Pakistan
Abstract
The research study was conducted with the objectives to evaluate the effect of various tillage practices on selected soil parameters including soil moisture content, bulk density and soil strength of sandy loam soil under rainfed condition during the wheat and chickpea growing seasons (2002 – 05). Five tillage treatments: No Till (NT); Chisel Plow once and Tine Type Cultivator twice (CPTC2); Moldboard Plow once and Tine type cultivator twice (MBTC2); Disk Harrow once and Tine Type Cultivator twice (DHTC2); and Tine Type Cultivator 3 times (TC3) were used in the study. The experiment was laid out in randomized complete block design (RCBD) with five treatments and four replications. The results showed that tillage treatments had significant effects on soil moisture content, bulk density and soil strength at 0 – 30 and 31 – 60 cm depths during the wheat – chickpea rotation growing seasons. By comparing soil moisture content at 0 – 30 and 31 – 60 cm depths during three consecutive years (2002 - 05) of wheat - chickpea rotations, it was noted that the mean higher soil moisture content of 10.54 and 10.90 % were found in deep tillage treatment (CHTC2 and MBTC2) and the lower soil moisture content of 8.57 and 8.85 % was recorded in No till, followed by tillage treatment TC3 (8.77 and 9.14%) respectively. By comparing, bulk density at 0 - 30 and 31 – 60 cm depths, the mean minimum bulk density of 1.39 and 1.44 g cm-3 were found in deep tillage plots (i.e. CHTC2 and MBTC2) and the higher bulk density of 1.46 and 1.47 g cm-3 was recorded in No till, followed by tine type cultivator 1.43 g cm-3 and1.47 g cm-3 respectively. Similarly soil strength at 0 - 30 cm depth, mean least soil strength of 527 N cm-2 was found in plots plowed by moldboard plow, followed by 548 N cm-2 in chisel plow plots, while the highest soil strength of 624 N cm-2 was observed in the No-till plots. At 31 – 60 cm depth, tillage treatment of chisel plow or moldboard plow resulted lowest value of 653.50 and 662.50 N cm-2 soil strength up to their plowing depth respectively, and in the No till treatments resulted highest value of 711 N cm-2. On an average, field prepared by chisel plow once and tine type cultivator twice (CHTC2) and moldboard plow once and tine type cultivator twice (MBTC2) were resulted higher soil moisture content, lower bulk density and soil strength as compared to No Till and shallow tillage treatments on sandy loam type of soil during wheat – chickpea rotation under rainfed condition.
Publication Details
Page(s) 71-80
DOI DOI not available
Published Journal: Sarhad Journal of Agriculture, Volume: 22, Issue: 1, Year: 2006

Request the full text from PASTIC

0

Citations

0

Downloads

76

Views