No Detail Found!

Morphological changes in cotton roots in relation to soil mechanical impedance and matric potential.

Author(s)
Ghulam-Nabi Land Resources Research Programme, Institute of Natural Resources and Environmental Sciences, NARC, Islamabad, Pakistan
C. E. Mullins Department of Plant and Soil Science, Cruickshank Building, University of Aberdeen, AB24 3UU, UK
Abstract
Soil mechanical impedance (MI) and matric potential can both cause reduction in the root growth rate, modify rooting pattern and root diameter. Cotton seedlings are sensitive to the soil physical environment, particularly during early stages of growth. Soil matric potential and MI effect on root biomass, axial root length and diameter, and the number and length of lateral roots in soil packed to penetration resistances (PR) of 0.1, 1.0, 1.1 and 1.2 MPa (megaPascal = 106 Pascal), each at three matric potentials of −10, −100 and −500 kPa (kiloPascal = 103 Pascal), were determined. Total root lengths were reduced by 29, 50 and 53% at impedance of 1.0, 1.1 and 1.2 MPa, respectively, as compared to the control, whereas MI of 1.2 MPa resulted in 60% reduction in axial root length. A similar increase in diameter was caused by increasing mechanical impedance, while decreasing matric potential had little effect. Roots that were water stressed did not change their diameter but had a shorter axis and longer lateral length. In contrast, the impeded roots (PR = 1.0, 1.1 and 1.2 MPa) had both a shorter axis and a smaller total length, but had increased diameter. These results not only illustrate the plasticity of root response to stress but also demonstrate how the response differs between different types of stresses.
Publication Details
Page(s) 349-354
DOI DOI not available
Published Journal: Pakistan Journal of Scientific and Industrial Research, Volume: 49, Issue: 5, Year: 2006

Request the full text from PASTIC

0

Citations

0

Downloads

100

Views