No Detail Found!

Computational Study of Mechanical Behavior of Ti6Al4V-Coated and Aluminium-Coated 316L Stainless Steel Alloy Under Linear and Cyclic Loading

Author(s)
S. M. A. Bukhari Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
A. Naveed Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
N. Husnain Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
F. A. Siddiqui Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
M. F. Zaman Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
A. Ahmad Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
R. Ahmad Department of Mechanical Engineering, Faculty of Engineering and Technology, Bahauddin Zakariya University, Multan, Pakistan.
N. Wajahat Department of Computer Science, Government Associate College for Women Kabirwala, Khanewal, Pakistan
Abstract
This study includes computational analysis of corrosion-resistant 316L Stainless Steel alloy after surface coating under linear and cyclic loading. Ti6Al4V is known for its strength and corrosion resistance whereas Aluminium alloy is known for its lightweight, enhanced surface finish and corrosion resistance. Based on this, two types of surface coatings are analyzed in this research work i.e. Ti6Al4V coating and Aluminium alloy coating. Effect of both the coatings on tensile and fatigue behaviors of coated 316L Steel specimens is explored. The testing specimen was designed in SolidWorks® 16.2 and analysis was done on ANSYS® Workbench 19.2. A thin layer (0.5 mm) of coating was made on 316L Stainless Steel specimen using ANSYS® Workbench 19.2. Coated specimens showed enhanced mechanical behavior as compared to specimens without coating. Moreover, the results indicated that Ti6Al4V coating provides superior properties as compared to Aluminium coating. Although Aluminium coating can reduce the cost and weight of the part but Aluminium coated 316L showed a reduced number of cycles while the cyclic load was applied whereas Aluminium coated specimen exhibited more strain as compared to Ti6Al4V coating. Ti6Al4V coating can be a good choice for Stainless Steel materials where certain desirable characteristics like high corrosion resistance, tensile strength, fatigue strength and low-crack initiation and propagation are required.
Publication Details
Page(s) 12-24
DOI DOI not available
Published Journal: Technical Journal, Volume: 28, Issue: 3, Year: 2023

Request the full text from PASTIC

Keywords
ANSYS, Simulation, tensile properties, factor of safety, coated steel, fatigue properties, - Surface coating
0

Citations

0

Downloads

63

Views