No Detail Found!

Designing and modelling of pivotal friction compensator of actuator of hard disk drives

Author(s)
Muhammad Umer Rana Department of Mechanical & Aerospace Engineering Air University,Islamabad,Pakistan
Syed Irtiza Ali Shah Department of Mechanical & Aerospace Engineering Air University,Islamabad,Pakistan
Muhammad Junaid Ansar Department of Mechanical & Aerospace Engineering Air University,Islamabad,Pakistan
Majid Mehmood Department of Mechanical & Aerospace Engineering Air University,Islamabad,Pakistan
Abstract
Nowadays, hard disk drives are one of the most common devices for storing data. The growing demand for storing the bulk amount of data and retrieving the data as fast as possible from hard disk drives (HDDs) has posed manufacturers with various challenges. To overcome these hurdles different methods, techniques, and control systems are developed to improve the transient response of the HDDs. The transient response of a system is characterized by numerous specifications such as overshooting, peak time, settling time, delay, and rise time. Transient response of the system can be achieved by using multiple stage actuators which can eventually increase the accuracy of head-positioning of the actuator of hard disk drives. By increasing the accuracy of read/write head actuator there is a challenge to cater the friction at pivot of actuator which can significantly reduce the speed of the actuator and leads to the reduction in the transient responses of the system. This paper aims to design a new modelled-base friction compensator for the servo control of hard disk drives that can compensate the pivotalfriction of actuator ofHDDs. To achieve this objective, measured and replicated responses will be used as guidance and the friction design of HDD will iteratively improve. This can be done by feeding the measuredfriction forces back to the voice coil motor so that the frequencies of the actuator's head and current can be linearized. This proposed design will help in the cancelation scheme and the model-based compensator will be implemented. We will test our design system against different types of response and then iteratively modify our system. Then, with the help ofMATLAB we will integrate a PID controller into our control system so that we can improve the transient response as much as possible. Our work can be considered important as there are very few frictions compensator control designs that have integrated the PID controller. We are aiming to achieve a significantly improved pivotal friction compensator that can help us to achieve improved transient response of the hard disk drive (HDD).
Publication Details
Page(s) 33-43
DOI DOI not available
Published Journal: New Horizons: Journal of the Institution of Electrical & Electronics Engineers Pakistan, Volume: 103, Issue: 1, Year: 2023

Request the full text from PASTIC

Keywords
Servomechanisms, PID controller, transient responses, friction, hard disk drives, head-positioning, Actuators
0

Citations

0

Downloads

34

Views