Pakistan is facing severe water scarcity and dealing with major water pollution problems, this study seeks to address these environmental challenges. The focus of this research is the development and application of activated carbon-based composite beads for contaminant removal and water purification. To achieve this goal, biopolymer composite beads were synthesized with chitosan (Cs) as matrix and activated carbon as filler, resulting in two types of beads: Cs blank beads and Cs/AC beads. The surface morphology of these beads was investigated by scanning electron microscopy (SEM) and the structure was elucidated by FTIR spectroscopy. The presence of chitosan polymer was verified at characteristic wavenumbers such as 3298 cm-1 (N-H stretching), 2905 cm-1 (CH stretching), 1570 cm-1 (NH bending), 1377 cm-1 (C-O-C), and 1033 cm-1 (C-OH). Furthermore, the study investigated the adsorption capacity of Cs/AC beads in the case of the extraction of methylene yellow pigment, a common pollutant in water The adsorption efficiency was tested by carefully measuring variables such as time of concentration, adsorbent concentration and pH. An optimization system was used to maximize extraction efficiency. Notably, the adsorption/removal of methylene yellow dye commenced upon exposure to Cs/AC, and after 150 minutes, a steady state was reached (92% removal), indicating no further removal. Consequently, this time point was identified as the optimal contact duration for subsequent investigations. Besides, a slightly acidic pH of 7 within the solution, coupled with higher concentrations of the adsorbent, was identified as the optimal condition. This research provides valuable insights into mitigating water pollution and improving water quality in Pakistan through the development and utilization of advanced composite materials.