The aging analysis of nuclear power plant being the major structural materials of nuclear power components and materials is crucial for the power plant's safety, plants, are also susceptible to thermally induced and for its upgradation and life extension. The health monitoring microstructural changes when subjected to ~270OC of power plant materials, such as steel, is mostly done by 290OC for extended periods of time [2]. Several studies employing conventional non-destructive evaluation (NDE) have reported aging of steel in power plants [1][2][3]. For techniques. Considering the limitations associated with safe and continuous operation of nuclear power plants, it conventional NDE techniques, thermoelectric power based NDE is necessary of keep a constant check on structural (TNDE) is being explored. This paper presents the first ever materials of primary/secondary piping, boilers and vessels development and successful demonstration of TNDE in etc. Carbon steel SA 106B is an important structural Pakistan. Moreover, the aging analysis of carbon steel grade SA 106B is also being presented for the first time. The extraction- material in nuclear power plants as it is used in piping of steam pipe samples (new and aged) of SA 106B, from a 46- main-steam and feedwater system. The condenser years-old operating nuclear power plant, are being analyzed and structural components and steam outlet nozzle are also the sensitivity of TNDE to aging induced changes in made up of this steel grade [4]. Several factors, including microstructure is demonstrated. Further, the aged SA 106B is but not limited to cyclic loading, corrosion, high simulated via heat treatment and the equipment is calibrated for temperature and irradiation, affect the materials properties. its utilization in the nuclear power plant. The correlation However, thermal aging is the main cause of between thermoelectric power (TEP) and Vicker hardness (HV) microstructural changes in carbon steel SA 106B [4]. [TEP (µV/oC) = ~2x10-5 Hardness (HV) + 0.008] has been analyzed. It is revealed that the technique has the potential to analyze mechanical properties of aged extraction steam piping without cutting and taking the samples to the laboratory.