During the past decade, different kinds of devices based on conjugated polymers, oligomers and low molecular weight organic semiconductors have been investigated widely. Lower material and fabrication cost of organic semiconductors are attracting extensive interest for their potential applications in organic devices. In particular it was found that phthalocyanine based Langmuir-Blodgett films conductivity was highly sensitive to NO and NO2 gases. Copper phthalocyanine (CuPc) films were sensitive to chlorine (Cl2), ammonia and NO2 gas. In this study, an investigation was made on the properties of organic semiconductor CuPc capacity humidity and illumination sensors. Organic thin film was deposited by vacuum evaporation on glass substrate with silver surface-type electrodes to form the surface-type Ag/CuPc/Ag sensor. The capacitance of the samples was evaluated at room temperature in the relative humidity range of 35-92%. It was observed that the capacitance of the Ag/CuPc/Ag sensor increases with a rise in humidity. The ratio of the relative capacitance to relative humidity was equal in average to 200. It is assumed that in general the capacitive response of the sensor is associated with polarization due to the absorption of water molecules and transfer of charges (electrons and holes). It was shown that under filament lamp illumination up to 1000 1x the capacitance of the Ag/CuPc/Ag photo capacitive detectors increased continuously up to 20% time with respect of dark condition. It is assumed that photo capacitive response of the sensors is associated with polarization due to the transfer of photo-generated electrons and holes. The equivalent circuit of the Ag/CuPc/Ag capacitive humidity and illumination sensor is developed. Humidity and illumination dependent capacitance properties of this sensor make it attractive for use in humidity and illumination multi-meters. As CuPc is sensitive not only to humidity and light but to number of other gases the surface-type structure sensor with CuPc film may be considered as multi-functional sensor. The sensor may be used in the instruments for environmental monitoring of humidity, illumination and some gases (NO2, Cl2 etc). Recently the surface type sensors were fabricated by us on the base of different organic materials, not only phthalocyanines, low molecular not only semiconductors and showed good response to effect of humidity, temperature, visible light and IR.