No Detail Found!

Analyses of Fatigue Resistance of Recycled AA 6061 by Hot Extrusion Using ANOVA Method

Author(s)
Mohammed H Rady Wasit University, College of Engineering, Al Kut, Wasit, Iraq
Ali Faraj Hammadi Wasit University, College of Engineering, Al Kut, Wasit, Iraq
Sandip A Kale Technology Research and Innovation Centre, Pune, India
Hussein R. Al-Bugharbee Wasit University, College of Engineering, Al Kut, Wasit, Iraq
Mohammad S. Mustapa Structural Integrity and Monitoring Research Group, Universiti Tun Hussein Onn Malaysia, Malaysia
Ravindra Garmode St. Francis Institute of Technology, Mumbai, India
Abstract
This study focuses on analyzing the fatigue life recovery in solid-state recycled (direct recycling without remelting) aluminium AA 6061 processed via the hot extrusion operation. The analyses were achieved by varying the factors of preheating temperature (PHT) at 450, 500 and 5500C and preheating time (PHti) at 1, 2, and 3 hours respectively. The effect of these parameters was analyzed on the fatigue of the produced alloy using the ANOVA technique in addition to the full factorial design with 2 replicates and 3 center points. From the result, it is indicated that the PHT parameter is more significant to be controlled rather than the PHti. An increase of PHT produced higher fatigue resistance. Among the selected parameters, extrudates show the best fatigue resistance at 550 °C and for 3 hours preheating. The analyses revealed that PHT was the main key parameter that takes control of the fatigue resistance in the recycling of the AA 6061 chip. Analysis of optical micrographs of the extrudates was also illustrated and discussed.
Publication Details
Page(s) 122-130
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 31, Issue: 2, Year: 2022

Request the full text from PASTIC

Keywords
ANOVA, extrusion, metal recycling, Aluminium AA 6061, fatigue resistance
0

Citations

0

Downloads

45

Views