The generation of a crystallized layer of hydroxycarbonate apatite (HCA) on the surface of the bioglasses after immersion in an SBF is thought to be the explanation of the bioactivity phenomena. We observed that adding minimal amounts of copper improves the performance of bioactive glasses. The aim of this study was to investigate the effect of the addition of CuO (0.2 - 4%) on the in vitro bioactivity behavior of bioactive silicate glasses. By soaking the prepared glasses in simulated bodily fluid (SBF) for one week, the behavior of the glass's bioactivity was examined. Then, different measurement methods, including scanning (SEM), FTIR spectra, and X-ray techniques, were used to evaluate the appearance of hydroxyapatite (HA). We observe the appearance of an IR band with two peaks at 560 and 604 cm-1 after soaking in simulated body fluid solution (SBF) in glasses with the addition of CuO (0.2 - 1%), which indicates the generation of a crystalline calcium phosphate phase that results in the formation of hydroxyapatite. SEM analyses reveal the distinctively distinctive crystals of hydroxyapatite that are supported by the FTIR results. The presence of the hydroxyapatite phase was detected through X-ray diffraction analysis. In the present research, we observed that adding minimal amounts of copper up to 1% improves the performance of bioactive studied glasses and increases the formation of a hydroxyapatite phase on the glass surface.