The average amount of municipal solid waste (MSW) generated in Malaysia is 0.5-0.8 kg/person/day and has increased to 1.7 kg/person/day in major cities. Due to rapid development and lack of space for new landfills, big cities in Malaysia are now switching to incineration. However, a major public concern over this technology also is the perception of the emission of pollutants of any form. Design requirements of high-performance incinerators are sometimes summarized as the achievement of 3Ts (time, temperature, and turbulence). An adequate retention time in hot environment is crucial to destroy the products of incomplete combustion and organic pollutants. Also turbulent mixing enhances uniform distributions of temperature and oxygen availability. CFD modeling is now in the development phase of becoming a useful tool for 3D modeling of the complex geometry and flow conditions in incinerators. However, CFD modeling of an industrial scale MSW incinerator was done using software FLUENT Ver.6.1. The 3D modeling was based conversation equations for mass, momentum and energy. The differential equations were discretized by the Finite Volume Method and were solved by the SIMPLE algorithm. The k-turbulence model was employed. The meshing was done using Gambit 2.0. The cold flow simulations were performed initially to develop the flow and velocity field. Using FLIC and FLUENT, it was possible to simulate all the three main phases of combustion i.e., the drying zone, devolatilization zone and the char burnout zone, Numerical simulations of the flow field inside the primary and secondary combustion chambers provided the temperature profiles and the concentration data at the nodal points of computational grids. The maximum temperature in the primary combustors for MSW and Mix fuel combustion were around 1600 K and 1900 K respectively. Parametric study was also done to minimize the NOx emissions. Nevertheless, the reactive flow modeling inside a MSW combustor has been done successfully using the FLIC and FLUENT programs. The results are useful in optimizing the design and operation of industrial waste combustors.