No Detail Found!

Porosity prediction using 3D seismic inversion Kadanwari Gas Field, Pakistan.

Author(s)
Nasir Ahmad Eni Pakistan, 5th Floor, The Forum, G-20, Block 9, Khayaban-e-Jami, Clifton, Karachi, Pakistan
Giacomo Spadini Eni Petroleum, Suite # 3500, 1201 Louisiana Street, Houston, United States of America
Arshad Palekar Eni Pakistan, 5th Floor, The Forum, G-20, Block 9, Khayaban-e-Jami, Clifton, Karachi, Pakistan
M. Asim Subhani Eni Pakistan, 5th Floor, The Forum, G-20, Block 9, Khayaban-e-Jami, Clifton, Karachi, Pakistan
Abstract
In the western part of the Kadanwari field a gas-bearing stratigraphic trap was identified in the G-sand of Lower Goru formation by drilling the X well. However, due to poor reservoir properties the well was not commercial. Thus, the challenge was to locate and quantitatively evaluate a drilling target in the sand body, which would have porosity values beyond the known producible threshold in the area. With this aim, 250 km2 of 3D seismic data was acquired in the area. The data was processed to pre-stack time migration, and acoustic impedance inversion was performed. This inverted data was used to generate a pseudo porosity volume to locate a “sweet spot” for porosity in the area. A linear relationship between Porosity and Acoustic Impedance was built based on the wire-line and CPI logs of the well X. The equation was obtained as a regression line for the clean G-sand porosity and acoustic impedance. The equation was applied to the available AIMP volume to obtain a pseudo-porosity volume. The inversion-derived pseudo-porosity was compared with the CPI porosity at well X. As expected, the pseudo-porosity obtained from inversion provided a result with frequency content similar to the seismic data. For this reason the calculated porosity was not able to describe the details of internal variations of the G-Sand but capable to catch the bulk character of the target sand only. Using this pseudo-porosity volume, a pseudo-porosity map was generated. On the basis of this work, the successful well Y was drilled. Due to the presence of complex mineralogy the effective porosity of well Y is still a question, however the sonic porosity was very close to the predicted porosity of 17-18%. On the basis of this success the Kadanwari Joint venture has decided to acquire 3D seismic in the all field area, to apply the same technique in order to fully evaluate the remaining potential. According to author’s knowledge this technique has not been used previously in the area for porosity prediction
Publication Details
Page(s) 95-102
DOI DOI not available
Published Journal: Pakistan Journal of Hydrocarbon Research, Volume: 17, Issue: 1, Year: 2007

Request the full text from PASTIC

0

Citations

0

Downloads

61

Views