Hydrocarbons are considered as the primary sources of energy in the world from several decades extracted by conventional means. Successful production of natural gas from the fine grained organic rich, silty shales is the latest advancement in the developed countries like USA, Canada, China, Argentina and Middle East. Usually, shales do not support unassisted flow due to the ultra low permeability (nano-Darcy). In order to meet the need of energy in Pakistan, the Government is fully devoted to test and exploit the gas shale resources of Pakistan. The primary objective of the study is to evaluate Shales of Sembar Formation by geochemical (quality and quantity of organic richness, thermal maturity), reservoir properties (porosity, water saturation) derived from petrophysical logs, estimated geomechanical properties (Youngs modulus, Poisson's ratio and brittleness) and gas initial in place (GIIP) status in the study area. Based on examined parameters, potential zones were identified in wells (X3 & X4), X2 well only for geochemical evaluation Organic shale reservoirs are dominantly composed of consolidated clay to silt sized particles with sufficient organic content and thermal maturity. Isopach maps shows that the average thickness of the Sembar Formation in the study area is approximately 600m with an average > 2 wt. % TOC with type II to III kerogen, 4 % gas filled porosity, <70% water saturation and is in condensate or wet gas window in the study area. Average Young Modulus 4 Mpsi and <0.3 Poisson's ratio. Cumulative GIIP of potential gas bearing zones is more than 100 SCF/TON or 45 BSCF/ Section (Free and adsorbed gas) over an area of 1359 acres.