In the present work, a gasoline car has alternatively been fuelled with methanol, with and without TWC (Three-Way Catalytic Converter) to investigate the aldehydes and BTEX (Benzene, Toluene, Ethyl Benzene, and Xylene) emissions, and their SR (Specific Reactivity). The car was run on an electric chassis dynamometer for transient as well as steady modes in accordance with the standard protocols. Aldehydes and BTEX components were analyzed using HPLC (High Performance Liquid Chromatography) and GC/MS (Gas Chromatography/Mass Spectroscopy), respectively. According to the results, formaldehydes were increased; however, acetaldehydes, acrolein+acetone, and benzaldehydes were decreased in case of M100 (Methanol without TWC) compared to M0 (Gasoline without TWC), in the transient mode. The aldehyde emissions were decreased in the cases of M0-W, (Gasoline with TWC) and M100-W (Methanol with TWC), relative to M0. Under the transient cycle, the BTEX emissions were greatly reduced in the cases of M100, M0-w, and M100-W, compared with M0. In the steady modes, formaldehydes of M100 were the most abundant components showing dominancy to those of M0; however, acetaldehydes of M100 were less than those of M0, formaldehydes were decreased with the increase in steady speed in cases of M100, and M100-W. There were significant abatements in the BTEX emissions of M100, M0-W, and M100-W compared to M0 for all the steady modes, and the total BTEX exhibited their maxima at lower speed mode for all the cases. Among the four operating conditions, M0-W presented the least SR in both the transient as well as steady modes.