No Detail Found!

Behavior of asphalt concrete mix using aggregates of different quarry sites in the vicinity of Hyderabad.

Author(s)
Nafees Ahmed Memon Department of Civil Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Arshad Ali Memon Department of Civil Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Rizwan Ali Memon Department of Civil Engineering, Mehran University of Engineering & Technology, Jamshoro, Pakistan
Abstract
In developing countries like Pakistan, the dramatic growth in vehicular traffic has augmented axle load and increased tyre pressure on the pavements resulting in the form of rutting and cracking. Compaction of asphalt concrete mixes plays a vital role on the performance of these payments. Quality of aggregates, their mix properties with the asphalt such as density, flow and air voids are highly dependent on the degree and method of compaction. This in turn affects the pavement performance indicators, such as bleeding and fatigue cracking. This paper presents the study of Asphalt Concrete Mix using the aggregates of different quarry sites in the vicinity of Hyderabad; Petaro, Parkar, Palari, G.H. Baloch, Onger and Khatar: Basic tests of all the coarse and fine aggregates were performed as per AASHTO, ASTM standards and same adopted by the NHA (National Highway Authority), Pakistan. Marshall method of asphalt mix design was used to design all the mixes of asphalt. The tests were conducted to check the basic properties of the Asphalt Concrete Mix i.e. density, flow, VFB (Voids Filled with Bitumen), Stability, VTM (Voids in total Mix) and VMA (Voids in Mineral Aggregates). The tests results reveal that the aggregates of all the quarry sites are in compliance with the specified limits adopted by the NHA. However, the aggregates of quarry site Petaro, produce the higher values of density, stability, and flow.
Publication Details
Page(s) 517-526
DOI DOI not available
Published Journal: Mehran University Research Journal of Engineering and Technology, Volume: 28, Issue: 4, Year: 2009

Request the full text from PASTIC

0

Citations

0

Downloads

104

Views