Matrix acidizing is a process where by an acid mixture is injected into the formation of interest to remove near Well bore damage and to increase porosity and permeability in Well bore regions by dissolving certain minerals. This is one of the method used to increase oil production in a well from a carbonate formation by using acid to dissolve reservoir rock. Matrix acidizing is done with pressure less than formation fracture pressure, and the acid flows through the natural permeability routes in the formation. Permeability of a rock is a measure of the ease with which fluid can flow through it. Formation permeability may be determined on the basis of core analysis, that measures permeability in only a small portion of the reservoir. Five samples (core plugs) were collected at different depths from Lower Goru Formation Badin block, sindh, Pakistan. A great deal of research and development has gone to optimize the maximum permeability from core plugs of Lower Goru formation through matrix acidizing. Two acid treatments were carried out in the laboratory in order to check the best acid selection. These acid treatments were selected for the purpose of removal of siliceous particles such as formation clay, feldspar and Quartz fines that are restricting near well bore permeability and plugging perforation tunnels. Petrographic study before and after acidizing has been done. Routine air Permeability was measured before and after matrix acidizing. Geologic characteristic of a formation can play a dominant role in acid stimulation in sandstone reservoirs. Laboratory experiments indicated that 12% HCL and 3% HF acid treatment was better for stimulating all core plugs of Lower Goru as compared to 3% of NH4CL acid treatment.