No Detail Found!

Emissions Reduction by Combustion Modeling in the Riser of Fluidized Bed Combustor for Thar Coal Pakistan

Author(s)
Jawad Abdullah Butt Department of Earth and Environmental Science, Bahria University Karachi Campus, Karachi, Pakistan
Yasmin Nergis Department of Earth and Environmental Science, Bahria University Karachi Campus, Karachi, Pakistan
Ahmad Hussain Department of Mechanical Engineering, DHA Suffa University, Karachi, Pakistan
Mughal Sharif Environmental Research Center, Bahria University Karachi Campus, Karachi, Pakistan
Arjan Das Department of Earth and Environmental Science, Bahria University Karachi Campus, Karachi, Pakistan
Abstract
Pakistan has experienced a protracted electricity shortage for the past few years. However, despite Pakistan's abundant coal deposits, modern coal combustion technology is still required to reduce emissions. Pakistan is struggling to utilize its energy resources and currently experiencing an electrical shortage of more than 8000 MW. The research study models the combustion performance in a fluidized bed riser using ANSYS FLUENT software to understand the combustion behavior of low-rank Thar coal. A simple circulating fluidized bed (CFB) combustion riser was modeled for computational fluid dynamics (CFD) to study the hydrodynamics of gas-solid flow in a circulating lfuidized bed riser to reduce emissions and operating costs. Three diferent types of risers/combustors geometries were used center flow, counter flow, and parallel flow. The CFD model for the solids segment with a k-e turbulence model and the viscosity of static particles in the gas segment both showed excellent mixing performance. According to the FLUENT data, the riser/combustor maximum temperature is around 1400 K or 1130 oC at the primary burning sector in the bed center. According to velocity contours, the greatest velocity in the center-oriented riser/combustor peaks at 3.3 m/s. The CO and CO both mass fraction counters show maximum concentration in the center geometry, whereas 2 lower CO concentration is found in parallel geometry. The lowest level of NOx is established in the parallel geometry at around 15 ppm, whereas the counter contours establish the maximum level of NOx at about 31 ppm. Circulating Fluidized Bed Combustor is found to be the most advantageous and efective technology for producing power from Thar lignite coal and reducing emissions.
Publication Details
Page(s) 61-70
DOI DOI not available
Published Journal: Proceedings of the Pakistan Academy of Sciences: B. Life and Environmental Sciences, Volume: 59, Issue: 4, Year: 2022

Request the full text from PASTIC

Keywords
Thar coal, Computational fluid dynamics, Circulating fluidized bed, Riser, Emissions reduction, Two-phase gas-solid flow model, Hydrodynamic
0

Citations

0

Downloads

172

Views