Because of the importance of rice cracking in milling process, precision control of drying conditions is important. For this purpose, it is necessary to determine drying kinetics and obtain the moisture change during the drying process. In this paper, design, fabrication and testing of an automated thin-layer dryer is presented. Experiments on the drying kinetics of rice paddy (Fajr cv.) were conducted at five drying air temperatures, ranging from 30 to 70, in four air velocities, ranging from 0.25 to 1.0 ms-1 and three replicas (60 runs altogether) with initial moisture content of 25% (d.b.) at the start of all runs. During drying, the mass loss was measured continuously. Experimental curves of the drying rate versus time grouped by air temperature showed the strong dependence of drying rate with temperature revealed that: (a) drying rate increased when air temperature increased and (b) moisture transfer occurred during the falling rate period of drying. However, when the curves of moisture ratio verses time were grouped by air velocity, very weak dependence of moisture ratio with velocity was observed. Increase in air velocity from 0.25 to 1 ms-1 had little effect on the drying period paddy. Drying curves obtained from the experimental data, fitted to eight thin layer models and compared with three statistical parameters, showed that two terms model can predict moisture change with grater accuracy than other models.