No Detail Found!

Characterization of nickel based spinel ferrites with small substitution of praseodymium.

Author(s)
Muhammad Tahir Farid Department of Physics, Bahauddin Zakariya University, Multan, Pakistan
Ishtiaq Ahmad Department of Physics, Bahauddin Zakariya University, Multan, Pakistan
Salma Aman Department of Physics, Bahauddin Zakariya University, Multan, Pakistan
Abstract
The influence of Pr3+ substitution on the structural, electrical and dielectric properties of Ni–Pr ferrites was studied in the ferrite series NiPr2xFe2-2xO4 where x = 0 to 0.10 in steps of 0.02. This series was prepared by sol gel method. XRD analysis reveals single phase samples up to x = 0.04. At x ≥ 0.06, a secondary phase of iron praseodymium oxide (PrFeO3) appears along with the spinel phase. The incorporation of Pr3+ for Fe3+ ions results in a slight increase of lattice constant due to larger ionic radius of the substituted ions. The electrical properties have been studied as a function of temperature. It is observed that dc electrical resistivity increases with increasing concentration of Pr3+ ions. The activation energy was found to increase with increasing Pr3+ ions. Dielectric constant, dielectric loss factor and dielectric loss tangent were measured at room temperature in the frequency range from 100 Hz to1MHz. A significant reduction in the values of dielectric constant and dielectric loss factor has been observed with the increase of Pr3+ ions. The high dc resistivity and low dielectric losses are the desired characteristics of Ni–Pr ferrites used to prepare microwave devices.
Publication Details
Page(s) 794-800
DOI DOI not available
Published Journal: Journal of Chemical Society of Pakistan, Volume: 35, Issue: 3, Year: 2013

Request the full text from PASTIC

0

Citations

0

Downloads

109

Views