No Detail Found!

Mechanical Characterization of Magnesium Alloy AZ31B Processed by Friction Stir Welding and Gas Tungsten Arc Welding

Author(s)
M.Y.Khan Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
N.A.Anjum Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
R.A.Pasha Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
S.Ahmad Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
A.Batool Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
J.Shafique Department of Mechanical Engineering, University of Engineering and Technology, Taxila, Pakistan
Abstract
Magnesium alloy AZ31B plates are welded utilizing two different welding techniques. One is friction stir welding, a strong solid state procedure, and other tungsten inert gas welding with alternating current, a famous fusion welding technique. Imperfection free, complete infiltration welds are acquired after several attempts utilizing different procedure parameters such as tool rotational speed, tool transverse speed, peak current, gas flow rate etc. Then impact of two welding methods are compared on mechanical properties of AZ31B joints that were assessed utilizing tensile test, fatigue test, Microhardness measurement, metallography, stereography and fractography. Welds obtained from friction stir welding technique showed better tensile and fatigue properties as compared with tungsten inert gas process. FSW gives tensile strength of 164.5 MPa and GTAW joint 121.5 MPa. Increment in the hardness is observed in the gas tungsten arc welded joint, and decrease in friction stir joints. Welds by friction stir technique demonstrated fine grains in the heat affected zone (HAZ), and also in the stir zone (SZ). It is revealed that both procedures are appropriate to get the good joints of the magnesium alloy AZ31B, but welds by friction stir process showed the stronger welds.
Publication Details
Page(s) 23-29
DOI DOI not available
Published Journal: Technical Journal, Volume: 24, Issue: 4, Year: 2019

Request the full text from PASTIC

Keywords
GTAW, Microhardness, Stereography, Fatigue test, Fractography, Tensile test, Metallography
0

Citations

0

Downloads

40

Views