No Detail Found!

Effect of coating-thickness on the formability of hot dip aluminized steel.

Author(s)
G. H. Awan Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
F. Ahmed Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
L. Ali Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
F. Hasan Department of Metallurgical & Materials Engineering, University of Engineering and Technology, Lahore, Pakistan
M. S. Shuja University of Lahore, 1-KM Defence Road, Lahore, Pakistan
Abstract
The influence for coating thickness on the formability and ductility of hot-dip aluminized steel has been determined using a 3-point bend test and optical metallography. The ductility formability was estimated from the 3-point bend test wherein the angle of bend at which the cracks start to appear on the surface of the aluminized sheet during bending, was taken as an index of the formability/ductility. It was observed that as the amount of silicon in the aluminizing melt was gradually increased the measured ductility of the sheet sample also increased. Metallographic examination has shown that as the amount of silicon in the aluminizing melt was increased the thickness of the intermediate compound layer, between the outer aluminum coat and the substrate steel, decreased. It was thus indicated from these experiments that the formability / ductility of the sheet was inversely related to the thickness of the interlayer.
Publication Details
Page(s) 14-21
DOI DOI not available
Published Journal: Pakistan Journal of Engineering and Applied Sciences, Volume: 2, Issue: , Year: 2008

Request the full text from PASTIC

0

Citations

0

Downloads

104

Views