No Detail Found!

Tensile Strength Analysis of IC Engine Connecting Rod Under 20kN Load for Aluminum Alloy (AL2024) and Grey Cast Iron

Author(s)
Reema Lashari Department of Mechanical Engineering,QUEST, Nawabshah, Sindh,Pakistan
Qadir Bakhsh Jamali Department of Mechanical Engineering,QUEST, Nawabshah, Sindh,Pakistan
Muhammad Ramzan Luhur Department of Mechanical Engineering,QUEST, Nawabshah, Sindh,Pakistan
Abdul Sattar Jamali Department of Mechanical Engineering,QUEST, Nawabshah, Sindh,Pakistan
Rashid Hussain Lashari Department of Civil Engineering,QUEST, Nawabshah, Sindh,Pakistan
Abstract
The application of load acting on a connecting rod during the combustion of fuel, often leads to the failure of the connecting rod and engine case. In this study, a connecting rod was designed based on selected dimensions and material in SOLIDWORKS tool. The connecting rod structural failure analysis under tension load has been carried out using SOLIDWORKS Finite Element Analysis (FEA) tool with aluminum alloy (AL2024) and grey cast iron material. The results show that with the selected design parameters and material, higher stresses are induced in the middle region (I-section) of the connecting rod if it is made of grey cast iron. The deformation of the model made of grey cast iron is also worse than the AL2024. The elongation of grey cast iron material is higher than the Al2024 by 0.1634 mm, and 0.14947 mm in Al2024 material. This study concluded that for better connecting rod design, the aluminum alloy Al2024 is a suitable material with very light weight and high tensile strength under 20kN load.
Publication Details
Page(s) 50-54
DOI DOI not available
Published Journal: Quaid-e-Awam University Research Journal of Engineering, Science and Technology, Volume: 17, Issue: 2, Year: 2019

Request the full text from PASTIC

Keywords
FEM, grey cast iron, aluminum alloy 2024, cast iron, Connecting rod, Internal combustion engine
0

Citations

0

Downloads

38

Views