No Detail Found!

Influence of contemporary CAD-CAM milling systems on the fit and adaptation of partially stabilized Zirconia fixed partial dentures

Author(s)
Khulud A Al-Aali Research Chair for Biological Research in Dental Health, King Saud University,Riyadh,Saudi Arabia
Rana S Alhamdan Research Chair for Biological Research in Dental Health, King Saud University,Riyadh,Saudi Arabia
Ahmed M Maawadh Research Chair for Biological Research in Dental Health, King Saud University,Riyadh,Saudi Arabia
Fahim Vohra Research Chair for Biological Research in Dental Health, King Saud University,Riyadh,Saudi Arabia
Tariq Abduljabbar Research Chair for Biological Research in Dental Health, King Saud University,Riyadh,Saudi Arabia
Abstract
Objective: To evaluate marginal fit and internal adaptation of three-unit Zr frameworks fabricated from four Zr CAD/CAM milling systems. Methods: Fixed partial denture models were replicated (40 stone models) using Polyvinyl Siloxane impression material (PVS) and type IV stone for Zr framework fabrication. FPDs were milled with four CAD/CAM systems, Group-II: LAVA™ Zirconia milled by LAVA™, Group-2: Vita In-Ceram YZ milled by Cerec®, Group-3: Zirconia milled by GM1000 and Group-4: Zirconia milled by DWX-50N. Twelve marginal gap measurements per framework were performed at pre-established points, with a metallurgical microscope (Zeiss, Germany) at 500X magnification. Eight measurements of cement space per section were performed for adaptation. Data was analyzed using ANOVA and Tukey post hoc test. Results: Zirconia FPD frameworks exhibited gaps ranging from 16 to 50.1 µm for marginal fit and 26.8 to 102.5 µm for internal adaptation. Group-3 [20.8 (8.3) µm & 50.3 (11.4) µm] and Group-4 [16.0 (4.0) µm & 40.2 (8.8) µm] specimens showed significantly lower marginal fit and internal adaptation gaps compared to Group-I [50.1 (13.4) µm & 100.5 (16.7) µm] and Group-2 [38.9 (8.2) µm & 102.5 (13.4) µm] specimens respectively. Conclusions: Different CAD-CAM systems for fabrication of Zr FPD frameworks displayed a significant influence on marginal fit and internal adaptation of restorations.
Publication Details
Page(s) 45-51
DOI DOI not available
Published Journal: Pakistan Journal of Medical Sciences, Volume: 37, Issue: 1, Year: 2021

Request the full text from PASTIC

Keywords
Fixed partial dentures, Internal adaptation, Milling parameters, Marginal fit, CAD-CAM
0

Citations

0

Downloads

57

Views