No Detail Found!

Effect of Top and Bottom Gating System in Sand Casting of Aluminum Alloy Al 6063-T5

Author(s)
A. M. Khan Nanjing University of Aeronautics and Astronautics, China
Q. Salman Department of Industrial Engineering, University of Engineering and Technology, Peshawar, Pakistan
A. R. Babar Department of Industrial Engineering, University of Engineering and Technology, Peshawar, Pakistan
S. Azim Department of Industrial Engineering, University of Engineering and Technology, Peshawar, Pakistan
R. Akhtar Department of Industrial Engineering, University of Engineering and Technology, Peshawar, Pakistan
Abstract
During casting process of light metals mold filling significantly affect the casted part. Top and bottom gating system is the most significant design consideration in sand casting. It directly effects the mold filling pattern and solidification time. In this research work, the effect of varying gate sizes with top and bottom configuration on the ultimate tensile strength, solidification time and mold filling time was analyzed. For this purpose, eight experiments were performed by varying top and bottom gating sizes while keeping all other parameters constant. ASTM standard samples were prepared and MTS machine was used to observe the UTS of samples. The Matlab software was used to draw the graphs to analyze the effect of top and bottom gating system on UTS. Bottom gating system exhibits better UTS contrary to top gating system.
Publication Details
Page(s) 9-16
DOI DOI not available
Published Journal: Journal of Pakistan Institute of Chemical Engineers, Volume: 46, Issue: 1, Year: 2018

Request the full text from PASTIC

Keywords
Aluminum Alloy6063 T5, Ultimate tensile strength, solidification time, Top and bottom gating system
0

Citations

0

Downloads

42

Views