No Detail Found!

Design of Broadband Matching Network for Complex Reactive Load using L-Matching

Author(s)
Jawad Yousaf Department of Electrical and Electronics Engineering, Sungkyunkwan University,Suwon,Republic of Korea
Zubair Mehmood Department of Electrical and Electronics Engineering, Sungkyunkwan University,Suwon,Republic of Korea
Waseem Abbas Department of Electrical and Electronics Engineering, Sungkyunkwan University,Suwon,Republic of Korea
Khuram Shehzad Department of Electrical and Electronics Engineering, Sungkyunkwan University,Suwon,Republic of Korea
Abstract
In this work, effect of single and multisection matching with and without ideal lumped components on the impedance matching bandwidth was analyzed. Single and multisection L-matching networks are designed for parallel reactive (RC) load configuration at 10 GHz. The analysis showed that higher section matching with ideal components did not produce significant improvement in fractional bandwidth of matching network for complex parallel RC load. However, more wider impedance bandwidth can be obtained with lower section matching constituting of finite component quality factor (Q) lumped components.
Publication Details
Page(s) 243-255
DOI DOI not available
Published Journal: Proceedings of the Pakistan Academy of Sciences: A. Physical and Computational Sciences, Volume: 54, Issue: 3, Year: 2017

Request the full text from PASTIC

Keywords
ideal/non-ideal lumped matching, L-matching, broadband impedance matching
0

Citations

0

Downloads

127

Views