Using the Matlab/Simulink software package a mathematical model of the electromechanical system of a shearer with an built-in moving system has developed. It takes into account all the main factors that determine its operating modes: electro-magnetic transients in drive motors for cutting and moving; dynamic forces in transmissions; the distribution of the cutting force between the cutting drive and drive for moving, the nature of the change in the moment of resistance forces during operation by changing the strength of the coal. The shearer control system contains a load regulator with a PI-controller. However, it was found that, despite the simplicity of the configuration and physical implementation, as well as the relatively high reliability, this class of control devices may not provide optimal operation of the control system in all modes due to the non-linearity of the control object and the random nature of the coal force changes as the shearer moves in the coal face. To overcome these shortcomings, the possibility of a neural-network implementation of correction of the PI-controller coefficients is considered. The possibility of the correction of the PI-controller coefficients controlling the speed of the shearer movement, with a random nature of the coal strength changing, is proposed and experimentally proved. It is shown that the use of the PI-controller with the corrector in the form of the neural network in the control system will increase performance of the load regulator by an average of 1.5-3 times in comparison with the classical regulator. All this will allow to avoid critical overloads, and hence the possible breakdown of the mechanical parts in the transmission of the shearer in case of a sudden collision of the executive body of the shearer with a solid inclusion.