In an attempt to create environmental friendly concrete, an investigation was carried out to determine the effects of adding non-biodegradable plastic fibers obtained from shredded waste polythene terephthalate bags on fresh and hardened properties of concrete. A pre-defined concrete mix was adopted with water to cement ratio of 0.45. Concrete mixtures were produced by adding 0.5% to 1.5% waste polythene fibers by weight of cement while keeping all other fractions the same. The size of the fibers was kept as 2cm × 3cm. Large size was selected because smaller polythene fibers would break very easily. Various tests performed on the fresh and hardened concrete show that the addition of plastic fibers changes fresh-state, physical and mechanical properties of concrete. The addition of plastics fibers increases in the workability of fresh concrete. However, plastic fibers reduce the density of hardened concrete and increase porosity and water absorption. Furthermore, on addition of these fibers reduction in the mechanical properties of concrete was observed. The addition of 1.5% fibers caused a reduction of 9.7%, 6.9% and 12.4% in split tensile strength, compressive strength and flexural strength of concrete respectively. Based on the experimental results it might be argued that the various concrete strength parameters decrease on addition of fibers but this reduction may be considered small compared to the benefits of its environmental friendly nature. Such concrete may be initially used in the non-structural applications such as barriers, curb stones, concrete blocks, and floor tiles.