No Detail Found!

Development of low cost indigenized soil moisture sensors for precision irrigation.

Author(s)
Usman Iqbal Department of Irrigation and Drainage, Faculty of Agricultural Engineering and Technology, University of Agriculture,Faisalabad,Pakistan
Allah Bakhsh Department of Irrigation and Drainage, Faculty of Agricultural Engineering and Technology, University of Agriculture,Faisalabad,Pakistan
Muhammad Adnan Shahid Water Management Research Center, University of Agriculture,Faisalabad,Pakistan
Syed Hamid Hussain Shah Department of Irrigation and Drainage, Faculty of Agricultural Engineering and Technology, University of Agriculture,Faisalabad,Pakistan
Shoukat Ali Institute of Agricultural Extension and Rural Development, Faculty of Social Sciences, University of Agriculture,Faisalabad,Pakistan
Abstract
Indigenized soil moisture sensors can be viable tools to improve water productivity through precision irrigation application. This study was conducted at Water Management Research Center, Postgraduate Agricultural Research Station, University of Agriculture, Faisalabad. Three types of soil moisture sensors were designed and fabricated using copper, brass, and steel. These sensors comprised a bottom tapered tip, middle tube/rod, and top handling part (packing foam). The length of the sensors was 30.48 cm, with bottom tip tapered at 33o over the length of 14.22 mm. The working principle was based on soil dielectric property through +ve electrode at the top and -ve electrode at bottom tip of the sensor tube. Type-I sensor had one probe, Type-II had two probes and Type-III had two insulated probes of galvanized steel. The electric current (mA) measured in response to the soil moisture status in the root zone was converted into digital form using microcontroller. These sensors were tested and calibrated against Gravimetric Method. The evaluation of Type-I, II, and III sensors showed that MBE (Mean Bias Error) was found to be within the acceptable limit of 2.5%, whereas RMSE (Root Mean Square Error) was lesser than 5% only in case of steel sensors and was out of the limit for all other sensors. The cost incurred on the indigenized sensors manufacturing was 10 times lesser than that of the imported. These research findings indicate that indigenized soil moisture sensors made of steel is relatively more accurate and can monitor real time soil moisture for promoting precision irrigation to improve water productivity.
Publication Details
Page(s) 205-217
Published Journal: Pakistan Journal of Agricultural Sciences, Volume: 57, Issue: 1, Year: 2020

Request the full text from PASTIC

Keywords
Soil moisture, monitoring, brass, galvanized steel, copper, double probe, sensor, steel, low cost., single probe
0

Citations

0

Downloads

97

Views