No Detail Found!

Pyrolysis of Polystyrene: The Influence of Commercially Available Oxides as Catalysts.

Author(s)
Jan Nisar National Center of Excellence in Physical Chemistry, University of Peshawar, Peshawar Pakistan
Muhammad Sufaid Khan National Center of Excellence in Physical Chemistry, University of Peshawar, Peshawar Pakistan
Ghulam Ali National Center of Excellence in Physical Chemistry, University of Peshawar, Peshawar, Pakistan
Afzal Shah Department of Chemistry, College of Science, University of Bahrain, Sakhir, Bahrain; Department of Chemistry, Quaid-i-Azam University, Islamabad, Pakistan
Rafaqat Ali Khan Department of Chemistry, COMSATS University Islamabad, Abbottabad Campus, Abbottabad, Pakistan
Faheem Shah Department of Chemistry, COMSATS University Islamabad, Abbottabad Campus, Abbottabad, Pakistan
Syed Tufail Hussain Sherazi National Centre of Excellence in Analytical chemistry, University of Sind, Jamshoro, Pakistan
Munawar Iqbal Department of Chemistry, The University of Lahore, Lahore, Pakistan.
Sirajuddin HEJ Research Institute of Chemistry, ICCBS, University of Karachi, Karachi, Pakistan
Abstract
Summary: In this study four catalysts (? -Alumina, a- Alumina, silica gel and silica ppt) with different physicochemical characteristics were tested for the pyrolysis of polystyrene (PS) under inert atmosphere in the temperature range 200-650 °C at heating rate 5 °C/min. The silica gel a mesoporous catalyst, with a greater pore size and surface area was found to be the most active materials in terms of reduction in maximum temperature. The ? -Alumina catalyst also shows good result because of the acidic sites, surface area, and pores size, however, its degradation effect is less than silica gel. The effect of a- Alumina catalyst on the pyrolysis of PS is less pronounced due to its small surface area, pore size and lack of acidic sites on its surface. The effects of these catalysts show that surface area, number of acidic sites and pore size were observed as the key factors for effective degradation of polymers.
Publication Details
Page(s) 779-787
DOI DOI not available
Published Journal: Journal of Chemical Society of Pakistan, Volume: 41, Issue: 5, Year: 2019

Request the full text from PASTIC

Keywords
Reduction in maximum degradation temperature, Catalytic thermal degradation
0

Citations

0

Downloads

71

Views