No Detail Found!

Desalination of Seawater using Lab Scale Solar Plant.

Author(s)
Zahid Naeem Qaisrania Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Mohammad Hashimb Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Syed Kamran Samib Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Syed Haseeb Sultan Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Mohammad Siddique Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Asadullah Department of Chemical Engineering, Balochistan University of Information Technology, Engineering and Management Sciences (BUITEMS), Quetta, Pakistan
Abstract
The current study describes the desalination of sea water using solar energy with particular focus on the design and fabrication aspects for single slope solar still. The purpose of this study was to present a novel, economically feasible methodology along with the equipment to overcome the water shortage particularly in the remote areas along the coastal belt in Pakistan. In order to achieve these objectives, a laboratory scale solar still was fabricated made of galvanized iron having basin area of 5490 cm2 (length of 90 cm and width of 61 cm), front height 15 cm and back height 32 cm. The Inclined angle was kept at 15o. The experiments were conducted during typical winter days. Results showed that when the highest ambient temperature was 29.9 °C, the maximum value of the average solar intensity was 1,080 W/m2. A remarkable decrease in terms of total suspended solids (TSS), total dissolved solids (TDS), thermal conductivity, hardness, turbidity, and pH was observed. The value of TDS decreased from 29,100 mg/L to 385 mg/L, TSS from 0.07 g/100mL to 0.00086 g/mL, thermal conductivity from 45,500 µs to 595µs, hardness 133 meq/L to 2.7 meq/L, turbidity from 29.3 NTU to 19.3 NTU, and pH from 9.36 to 6.22, respectively. Furthermore, temperature profile against the intensity was drawn to identify the peak efficient hours with highest heat intensity. The suggested technique cannot only give a solution for the domestic level use rather it can be utilized in commercial scale in solar desalination facilities.
Publication Details
Page(s) 221-227
DOI DOI not available
Published Journal: Journal of Applied and Emerging Sciences , Volume: 9, Issue: 1, Year: 2019

Request the full text from PASTIC

0

Citations

0

Downloads

59

Views