No Detail Found!

Metal removal with carboxymethyl chitosan using small columns.

Author(s)
Zeenat M. Ali Chemical Engineering Department, Mehran University of Engineering and Technology (MUET), Jamshoro, Pakistan
Shuaib M. Laghari Civil Engineering Department, Universiti Teknologi PETRONAS, Tronoh, Perak, Malaysia
A. Jabbar Laghari ARSCS HiTech RLs, University of Sindh, Jamshoro Pakistan
M. M. Tunio Energy and Environment Engineering, Quaid-e-Awam University of Engineering, Science and Technology (QUEST), Nawabshah, Pakistan
Abstract
Chitosan has reactive amino (NH2) & hydroxyl (OH) groups on its skeleton, which could be used for chemical modifications under mild reaction conditions to alter its properties. In present work the alkylation method was opted for the preparation of carboxymethyl chitosan. The characterization of the compound was carried out via scanning electron microscopy, energy dispersive x-rays and fourier transformation infrared (FTIR) techniques. Five small columns were prepared each contained 2 gram carboxymethyl chitosan. The columns carried copper (11), zinc (II), chromium (III), iron (H) and nickel (II) solutions having concentrations of 10-100 ttg/L. When compared the order was Cu>Zn>Cr>Fe>Ni. The removal efficiency of over 86.4% - 95.1% and recovery of 100% was observed from wastewater for copper (132 mg/L), zinc (171 mg/L), chromium (118 mg/L), iron (353 mg/L) and nickel (96mg/L).
Publication Details
Page(s) 70-74
DOI DOI not available
Published Journal: Quaid-e-Awam University Research Journal of Engineering, Science and Technology, Volume: 15, Issue: 1, Year: 2016

Request the full text from PASTIC

0

Citations

0

Downloads

29

Views