A new cone pressure meter has been developed at the University of Engineering and Technology, Lahore, Pakistan called APMT (Akbar Pressuremeter). This paper is based on the APMT testing of a cohesive soil deposit comprising low plastic CL (Lean Clay) to CL-ML (Sandy Silty Clay). The APMT testing was carried out by full displacement technique along with SPT (Standard Penetration Testing) and UDS (Undisturbed Sampling) at two locations each. The soil samples obtained were used to determine soil type and soil strength. The pressuremeter parameters viz. soil strength and stiffness have been determined from the corrected pressure-cavity strain curves of each APMT test. These parameters have been compared with those determined from laboratory methods and good agreements have been observed.