A study was conducted in the Department of Structures and Environmental Engineering, University of Agriculture, Faisalabad during the year 2014 to characterize the wastewater and low cost implementation for treatment of dyeing wastewater. The study area was selected near Faisalabad during April to August 2014. For treated and untreated samples hydrogen ion concentration (pH), total dissolved solids (TDS), total suspended solids (TSS), biological oxygen demand (BOD), chemical oxygen demand (COD), sulphate, sulfides and chloride contents were observed by using standard procedures. These parameters varied in the range of 7.03-7.16, 1799-2323 mg/L, 515-1059 mg/L, 187-220 mg/L, 235-431 mg/L, 464-995 mg/L, 20-35 mg/L and 404-518 mg/L, respectively. Alum was found better at dosage of 210 mg/L, activated carbon at 6g/L and combination of both at 210:9. The efficient removal was found in TSS, BOD, COD and chloride contents. Sulphates and sulfides were increased by using alum and combination during treatment. Correlation among the dyeing effluents of three industries was found in the range of 92-100 percent.